What to do with 401 biscayne blvd. r-200

Relying on superb technologies, better support for patrons. Actualtests offer 24 hour customer care regarding Cisco examinee and you will get what you want know anytime. Your pleasure of our own [productsort] is actually our own support purpose, their shared development with clients is actually our own continual pursuit in a large number. Thus please dont wait to get hold of us all for those who have questions associated with [productsort] test.

2021 Aug 401 biscayne blvd. r-200:

Q31. - (Topic 1) 

What are two benefits of a star network topology? (Choose two.) 

A. Disruption of the entire network is not required when adding new machines. 

B. Any problem which leaves the network inoperable can be traced to the central hub. 

C. This network type requires less cable as compared to linear bus topology. 

D. The performance of one of the numerous nodes cannot reflect on the performance of other nodes. 

E. The performance of the entire network is directly dependent on the performance of the hub. 

Answer: A,B 

Q32. - (Topic 2) 

Exhibit: 

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration? 

A. These commands need to be added to the configuration:C-router(config)# router eigrp 123C-router(config-router)# network 172.19.0.0 

B. These commands need to be added to the configuration:C-router(config)# router ospf 1C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0 

C. These commands need to be added to the configuration:C-router(config)# router ripC-router(config-router)# network 172.19.0.0 

D. No further routing configuration is required. 

Answer: D 

Q33. - (Topic 4) 

What is the leading cause of fiber-optic link failure? 

A. contaminants 

B. crushed fiber 

C. poor testing practices 

D. bad connectors 

Answer: A 

Q34. - (Topic 5) 

Exhibit: 

Refer to the exhibit. A technician enters the exhibited commands to configure a new router on the plant floor, but receives an error message when attempting to save the configuration. What can the technician do to correct the problem? 

A. Enter the correct command. 

B. Enter the command at the correct prompt. 

C. Upgrade the amount of flash memory in the router. 

D. Erase NVRAM to make room for the configuration file. 

E. Add NVRAM because there is not enough room for the configuration file. 

Answer: A 

Q35. - (Topic 2) 

What is the purpose of Spanning Tree Protocol? 

A. to prevent routing loops 

B. to create a default route 

C. to provide multiple gateways for hosts 

D. to maintain a loop-free Layer 2 network topology 

E. to enhance the functions of SNMP 

Answer: D 

Abreast of the times viessmann vitobloc 200 em-401/549:

Q36. - (Topic 4) 

At which Layer would you use trace route to validate the path? 

A. Layer 1 

B. Layer 2 

C. Layer 3 

D. Layer 4 

Answer: C 

Q37. - (Topic 3) 

With what are APC connectors used? 

A. Category 6a cables that need tight radius bends 

B. copper network cables in corrosive environments 

C. single-mode fiber-optic cables to reduce return loss 

D. high-density copper patch panels 

Answer: C 

Q38. - (Topic 4) 

An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is turned on and the switch port link LED turns green. The link light indicates what two conditions? (Choose two.) 

A. Layer 2 communication has been established between the PC and switch. 

B. The PC has received a DHCP address. 

C. Traffic is being sent from the switch to the PC. 

D. If flashing, the green LED indicates port speed of 100 Mb/s. 

E. The Layer 1 media is functioning between the PC and switch. 

F. The switch port is functioning as a half-duplex connection. 

Answer: A,E 

Q39. - (Topic 4) 

With a Cisco IE 2000 switch, what does a port status LED indicate when it is alternating green and amber? 

A. The port is sending or receiving data. 

B. A link is present. 

C. No link is present. 

D. There is a link fault. 

E. The port is not forwarding. 

Answer: D 

Q40. - (Topic 3) 

Which option best describes a mechanical, ingress, climatic, chemical and electromagnetic environment that is classified as M3 I3 C3 E3? 

A. the highest quality 

B. office environment 

C. severe 

D. serviced by multiple cable segments 

Answer: C