Our pass rate is high to 98.9% and the similarity percentage between our 300-365 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 300-365 exam in just one try? I am currently studying for the Cisco 300-365 exam. Latest Cisco 300-365 Test exam practice questions and answers, Try Cisco 300-365 Brain Dumps First.
Q11. What is the best practice for setting the WLC v7.0 use of WLAN QoS settings to support SIP phones on a VoWLAN?
A. Configure SIP with static CAC only with SIP call snooping.
B. Configure SIP with static CAC only without SIP call snooping.
C. Configure SIP with load-based CAC only with SIP call snooping.
D. Configure SIP with load-based CAC only without SIP call snooping.
E. Configure SIP with load-based CAC and TSPEC only with SIP call snooping.
Q12. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue?
A. controller IGMP snooping
B. unicast AP Multicast Mode
C. broadcast forwarding
D. multicast AP Multicast Mode
Q13. A customer has limited staff to manage a wireless network. The customer wants a solution that requires minimum hardware. Which type of architecture do you propose?
Q14. After implementing mDNS gateway, a school's network administrator notices that mDNS wireless printers are available over the whole network. Which feature can the admin use to restrict the printer mDNS advertisements to the AP that the printer is joined to and adjacent APs?
D. Priority MAC
Q15. What devices can be tracked with the Cisco Context Aware Services?
A. Only wired devices.
B. Both wired and wireless devices.
C. Only Cisco certified wireless devices.
D. Only wireless devices.
Q16. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three)
A. verify that Global Multicast mode has been enabled
B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients.
C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN
Q17. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video?
A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity.
B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often.
C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade.
D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps.
Q18. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)
A. All ports participate in the LAG by default when LAG is enabled on the controller, y
B. Dynamic interfaces and management are moved to port 1
C. Primary and secondary ports are needed for each interface.
D. Multiple untagged interfaces to the same port are not allowed.
E. EtherChannel must be configured for mode "on" on the switch.
F. Only one functional physical port is needed to continue to pass traffic.
G. Multiple LAGs are permitted on the controller.
H. The WLC does not need to be rebooted to enable the LAG configuration.
Q19. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal?
A. mobility groups
B. flex-connect groups
C. interface groups
D. AP groups
Q20. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented. How should the engineer perform the password recovery?
A. Use a console cable.
B. Contact Cisco TAC and arrange an RMA of the MSE.
C. Boot the MSE using the software installation DVD.
D. The Password can be reset using Prime Infrastructure.
To know more about the 300-365, click here.