200-101 Guide

Questions Ask for ccna vs icnd1 and icnd2

Most of the customers preserve trust on us because of the warranty that above 95% passing guarantee. Normally, full refund or even another items. We also provide together with consolation for the unsuccessful consumers. Without virtually any delay if that they fail the Cisco Cisco exam. Only contact the Customer Assist to claim the actual refund or trade the items. Further much more, you have to attach the actual failed transcript.

2021 Sep icnd2 practice:

Q11. Refer to the exhibit. **Exhibit Missing**

A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified as correct. What is the cause of the problem? 

A. The serial cable on R1 needs to be replaced. 

B. The interfaces on R2 are not configured properly. 

C. R1 has no route to the 192.168.1.128 network. 

D. The IP addressing scheme has overlapping subnetworks. 

E. The ip subnet-zero command must be configured on both routers. 

Answer: C 


Q12. Refer to the exhibit. 


Assume that all of the router interfaces are operational and configured correctly. How will router R2 be affected by the configuration of R1 that is shown in the exhibit? 

A. Router R2 will not form a neighbor relationship with R1. 

B. Router R2 will obtain a full routing table, including a default route, from R1. 

C. R2 will obtain OSPF updates from R1, but will not obtain a default route from R1. 

D. R2 will not have a route for the directly connected serial network, but all other directly connected networks will be present, as well as the two Ethernet networks connected to R1. 

Answer: A 


Q13. Which three of these statements regarding 802.1Q trunking are correct? (Choose three.) 

A. 802.1Q native VLAN frames are untagged by default. 

B. 802.1Q trunking ports can also be secure ports. 

C. 802.1Q trunks can use 10 Mb/s Ethernet interfaces. 

D. 802.1Q trunks require full-duplex, point-to-point connectivity. 

E. 802.1Q trunks should have native VLANs that are the same at both ends. 

Answer: ACE 


Q14. Refer to the exhibit. 


Assume that all router interfaces are operational and correctly configured. In addition, assume that OSPF has been correctly configured on router R2. How will the default route configured on R1 affect the operation of R2? 

A. Any packet destined for a network that is not directly connected to router R1 will be dropped. 

B. Any packet destined for a network that is not directly connected to router R2 will be dropped immediately. 

C. Any packet destined for a network that is not directly connected to router R2 will be dropped immediately because of the lack of a gateway on R1. 

D. The networks directly connected to router R2 will not be able to communicate with the 172.16.100.0, 172.16.100.128, and 172.16.100.64 subnetworks. 

E. Any packet destined for a network that is not referenced in the routing table of router R2 will be directed to R1. R1 will then send that packet back to R2 and a routing loop will occur. 

Answer: E 


Q15. Which PPP subprotocol negotiates authentication options? 

A. NCP 

B. ISDN 

C. SLIP 

D. LCP 

E. DLCI 

Answer: D 


200-101 exams

Refresh numbers 101-200:

Q16. What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology? 

A. It avoids split-horizon issues with distance vector routing protocols. 

B. IP addresses can be conserved if VLSM is not being used for subnetting. 

C. A multipoint interface offers greater security compared to point-to-point subinterface configurations. 

D. The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations. 

Answer: B 


Q17. Refer to the exhibit. 


Which WAN protocol is being used? 

A. ATM 

B. HDLC 

C. Frame Relay 

D. PPP 

Answer: C 


Q18. Which port state is introduced by Rapid-PVST? 

A. learning 

B. listening 

C. discarding 

D. forwarding 

Answer: C 


Q19. What would be the destination Layer 2 address in the frame header for a frame that is being forwarded by Dubai to the host address of 172.30.4.4? 




A. 825 

B. 230 

C. 694 

D. 387 

Answer: C 


Q20. Refer to the exhibit. 


Which of these correctly describes the results of port security violation of an unknown packet? 

A. port enabled; unknown packets dropped; no SNMP or syslog messages 

B. port enabled; unknown packets dropped; SNMP or syslog messages 

C. port disabled; no SNMP or syslog messages 

D. port disabled; SNMP or syslog messages 

Answer: D 


To know more about the 200-101, click here.

Tagged as : Cisco 200-101 Dumps, Download 200-101 pdf, 200-101 VCE, 200-101 pass4sure, examcollection 200-101