Guaranteed of 200-101 rapidshare materials and bundle for Cisco certification for IT professionals, Real Success Guaranteed with Updated 200-101 pdf dumps vce Materials. 100% PASS Interconnecting Cisco Networking Devices Part 2 (ICND2) exam Today!
Q31. What is the purpose of Inverse ARP?
A. to map a known IP address to a MAC address
B. to map a known DLCI to a MAC address
C. to map a known MAC address to an IP address
D. to map a known DLCI to an IP address
E. to map a known IP address to a SPID
F. to map a known SPID to a MAC address
Q32. Refer to the exhibit.
Each of these four switches has been configured with a hostname, as well as being configured to run RSTP. No other configuration changes have been made. Which three of these show the correct RSTP port roles for the indicated switches and interfaces? (Choose three.)
A. SwitchA, Fa0/2, designated
B. SwitchA, Fa0/1, root
C. SwitchB, Gi0/2, root
D. SwitchB, Gi0/1, designated
E. SwitchC, Fa0/2, root
F. SwitchD, Gi0/2, root
Q33. Refer to the exhibit.
At the end of an RSTP election process, which access layer switch port will assume the discarding role?
A. Switch3, port fa0/1
B. Switch3, port fa0/12
C. Switch4, port fa0/11
D. Switch4, port fa0/2
E. Switch3, port Gi0/1
F. Switch3, port Gi0/2
Q34. Refer to the exhibit.
C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?
A. These commands need to be added to the configuration: C-router(config)# router eigrp 123 C-router(config-router)# network 172.19.0.0
B. These commands need to be added to the configuration: C-router(config)# router ospf 1 C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
C. These commands need to be added to the configuration: C-router(config)# router rip C-router(config-router)# network 172.19.0.0
D. No further routing configuration is required.
Q35. After the network has converged, what type of messaging, if any, occurs between R3 and R4?
A. No messages are exchanged.
B. Hellos are sent every 10 seconds.
C. The full database from each router is sent every 30 seconds.
D. The routing table from each router is sent every 60 seconds.
Q36. Refer to the exhibit.
The network is converged. After link-state advertisements are received from Router_A, what information will Router_E contain in its routing table for the subnets 18.104.22.168 and 22.214.171.124?
A. O 126.96.36.199 [110/13] via 188.8.131.52, 00:00:07, FastEthernet 0/0 O 184.108.40.206 [110/13] via 220.127.116.11, 00:00:16, FastEthernet 0/0
B. O 18.104.22.168 [110/1] via 22.214.171.124, 00:00:07, Serial 1/0 O 126.96.36.199 [110/3] via 188.8.131.52, 00:00:16, FastEthernet 0/0
C. O 184.108.40.206 [110/13] via 220.127.116.11, 00:00:07, Serial 1/0 O 18.104.22.168 [110/13] via 22.214.171.124, 00:00:16, Serial 1/0 O 126.96.36.199 [110/13] via 188.8.131.52, 00:00:16, FastEthernet 0/0
D. O 184.108.40.206 [110/3] via 220.127.116.11, 00:00:07, Serial 1/0 O 18.104.22.168 [110/3] via 22.214.171.124, 00:00:16, Serial 1/0
Q37. What are three reasons that an organization with multiple branch offices and roaming users might implement a Cisco VPN solution instead of point-to-point WAN links? (Choose three.)
A. reduced cost
B. better throughput
C. broadband incompatibility
D. increased security
F. reduced latency
Q38. What is the default administrative distance of OSPF?
Q39. Which two statistics appear in show frame-relay map output? (Choose two.)
A. the number of BECN packets that are received by the router
B. the value of the local DLCI
C. the number of FECN packets that are received by the router
D. the status of the PVC that is configured on the router
E. the IP address of the local router
Q40. The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR? (Choose two.)
To know more about the 200-101, click here.