200-101 Guide

Get Smart with icnd2 practice exam

You should be conscious of the essential concepts and implementation from the Cisco Cisco exam. So many types of preparation materials are available from the market that will it becomes more hard for an aspirant for you to fetch the correct and undemanding research materials. The proper research material is involving great significance for a candidate for you to prepare for Cisco 200-101 exam. A seem knowledge from the exam dumps makes the actual information understandable as well as efficient. It can help the actual candidate in implementation. All of the key concepts as well as topics are concerned in the Examcollections 200-101 exam braindumps that are revised by technical experts team. The candidates will master all the essential exam contents and perform well from the real exam.

2021 Oct icnd2 practice test:

Q1. Which statements are true about EIGRP successor routes? (Choose two.) 

A. A successor route is used by EIGRP to forward traffic to a destination. 

B. Successor routes are saved in the topology table to be used if the primary route fails. 

C. Successor routes are flagged as 'active' in the routing table. 

D. A successor route may be backed up by a feasible successor route. 

E. Successor routes are stored in the neighbor table following the discovery process. 

Answer: AD 


Q2. Which command allows you to verify the encapsulation type (CISCO or IETF) for a Frame Relay link? 

A. show frame-relay lmi 

B. show frame-relay map 

C. show frame-relay pvc 

D. show interfaces serial 

Answer: B 


Q3. OSPF is configured using default classful addressing. With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be learned by OSPF? 



A. 2 

B. 3 

C. 4 

D. 5 

E. 6 

F. 7 

Answer: C 


Q4. Refer to the exhibit. 


Given the output from the show ip eigrp topology command, which router is the feasible successor? 

A) 


B) 


C) 


D) 


A. Exhibit A 

B. Exhibit B 

C. Exhibit C 

D. Exhibit D 

Answer: B 


Q5. Refer to the exhibit. 


Which switch provides the spanning-tree designated port role for the network segment that services the printers? 

A. Switch1 

B. Switch2 

C. Switch3 

D. Switch4 

Answer: C 


200-101 free practice exam

Improved icnd2 exam:

Q6. Refer to the exhibit. 


A technician has configured the FastEthernet 0/1 interface on Sw11 as an access link in VLAN 1. Based on the output from the show vlan brief command issued on Sw12, what will be the result of making this change on Sw11? 

A. Only the hosts in VLAN 1 on the two switches will be able to communicate with each other. 

B. The hosts in all VLANs on the two switches will be able to communicate with each other. 

C. Only the hosts in VLAN 10 and VLAN 15 on the two switches will be able to communicate with each other. 

D. Hosts will not be able to communicate between the two switches. 

Answer: D 


Q7. If required, what password should be configured on the DeepSouth router in the branch office to allow a connection to be established with the MidEast router? 




A. No password is required. 

B. Enable 

C. Secret 

D. Telnet 

E. Console 

Answer: B 

In the diagram, DeepSouth is connected to Dubai’s S1/2 interface and is configured as follows: 

Interface Serial1/2 IP address 192.168.0.5 255.255.255.252 Encapsulalation PPP ; Encapsulation for this interface is PPP 

Check out the following Cisco Link: 

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a008009 4333.shtml#configuringausernamedifferentfromtheroutersname 

Here is a snipit of an example: 

Network Diagram 

If Router 1 initiates a call to Router 2, Router 2 would challenge Router 1, but Router 1 would not challenge Router 2. This occurs because the ppp authentication chap callin command is configured on Router 1. This is an example of a unidirectional authentication. In this setup, the ppp chap hostname alias-r1 command is configured on Router 1. Router 1 uses "alias-r1" as its hostname for CHAP authentication instead of "r1." The Router 2 dialer map name should match Router 1's ppp chap hostname; otherwise, two B channels are established, one for each direction. 



Q8. DRAG DROP 


Answer: 



Q9. Which statement is true, as relates to classful or classless routing? 

A. Classful routing protocols send the subnet mask in routing updates. 

B. RIPv1 and OSPF are classless routing protocols. 

C. Automatic summarization at classful boundaries can cause problems on discontiguous subnets. 

D. EIGRP and OSPF are classful routing protocols and summarize routes by default. 

Answer: C 


Q10. Refer to the exhibit. 


RTA is configured with a basic configuration. The link between the two routers is operational and no routing protocols are configured on either router. The line shown in the exhibit is then added to router RTA. Should interface Fa0/0 on router RTB shut down, what effect will the shutdown have on router RTA? 

A. A route to 172.16.14.0/24 will remain in the RTA routing table. 

B. A packet to host 172.16.14.225 will be dropped by router RTA. 

C. Router RTA will send an ICMP packet to attempt to verify the route. 

D. Because router RTB will send a poison reverse packet to router RTA, RTA will remove the route. 

Answer: A 


To know more about the 200-101, click here.

Tagged as : Cisco 200-101 Dumps, Download 200-101 pdf, 200-101 VCE, 200-101 pass4sure, examcollection 200-101