200-355 Guide

All About 200-355 free practice questions Mar 2021

It is impossible to pass Cisco 200-355 exam without any help in the short term. Come to Actualtests soon and find the most advanced, correct and guaranteed Cisco 200-355 practice questions. You will get a surprising result by our Down to date Implementing Cisco Wireless Network Fundamentals practice guides.

2021 Mar 200-355 practice exam

Q61. A network engineer in the GUI of WCS version 7 wants to add an access point to a map. Where can this command be found within the drop-down menu? 

A. Monitor > Maps 

B. Reports > Maps 

C. Monitor > Network Summary 

D. Configure > Maps 

Answer:


Q62. Which path do you take to manage the results of a report that had been run on network utilization? 

A. Reports > Report Launch Pad > Device > Utilization 

B. Reports > Report Launch Pad > Scheduled Run Results 

C. Reports > Saved Reports > Scheduled Run Results 

D. Reports > Scheduled Run Results 

Answer:


Q63. Old 2.4-GHz wireless laptops are unable to connect. What is the most likely cause of this problem? 

A. WLAN > General properties are incorrectly configured. 

B. WLAN > QoS properties are incorrectly configured. 

C. WLAN > Security properties are incorrectly configured. 

D. WLAN > Advanced properties are incorrectly configured. 

E. Wireless > AP > 802.11 b/g/n AP is incorrectly configured. 

F. Wireless > AP > 802.11 b/g/n > Network is incorrectly configured. 

Answer:


Q64. Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true? 

A. The overhead associated with supporting both encryption methods significantly degrades client throughput. 

B. Some wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN. 

C. This configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected. 

D. This configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration. 

Answer:


Q65. Which information on the Monitoring page of a Cisco WLC verifies that the wireless network is operational? 

A. In the Access Point Summary section, the All APs number in the Up column is the same as in the Total column. 

B. In the Client Summary section, the Current Clients number is positive. 

C. In the Controller Summary section, the 802.11b/g Network State is shown as Enabled. 

D. In the Controller Summary section, the CPU Usage number is positive. 

Answer:


Regenerate 200-355 dumps:

Q66. Refer to the exhibit. 

Cisco WCS version 7.0 has a configuration mismatch with what is actually running in the controller. Which menu leads to the Audit Status Report? 

A. Security 

B. Monitor 

C. Configure 

D. Services 

E. Administration 

F. Tools 

Answer:


Q67. The AP is unable to join the WLC. What switch configuration will correct this problem? 

A. interface vlanl ip helper-address 10.10.10.10 

B. interface vlan20 ip helper-address 10.10.10.10 

C. ipdhcp pool vlanl option 43 ascii '10.10.10.10' 

D. ip dhcp pool vlan20 option 43 ascii '10.10.10.10' 

E. ipdhcp pool vlanl option 43 hex f1040a0a0a0a 

F. ip dhcp pool vlan20 option 43 hex f1040a0a0a0a 

Answer:


Q68. An AP using version 7.0 MR1 broadcasts a Layer 3 CAPWAP discovery message on the local IP subnet. Which step does the AP take next? 

A. Determine if the controller responses include the primary controller. 

B. Determine if the controller responses include the master controller. 

C. Send a discovery request using DHCP option 43. 

D. Send a discovery request using DNS. 

E. Send a discovery request using locally stored information on the AP. 

F. Send a discovery request using OTAP. 

Answer:


Q69. Which Cisco AnyConnect module provides wireless connectivity? 

A. telemetry 

B. web security 

C. VPN 

D. NAM 

E. DART 

F. posture 

G. CSSC 

Answer:


Q70. You have brought your MacBook Pro running OS 10.6 to work and intend use the enterprise wireless network. This network is using EAP-FAST and 2.4 GHz for data and 5 GHz for VoWLAN. 

Which statement about the laptop configuration and wireless connection is true? 

A. Install a USB wireless adapter and configure 

B. Install Apple EAP-Fast plug-in and configure 

C. Install Cisco AnyConnect v2.4 and configure 

D. Configure Apple network preferences for EAP-FAST 

E. The laptop does not support EAP-FAST and will be unable to connect 

F. The laptop only supports 5 GHz and will be unable to connect 

Answer:


To know more about the 200-355, click here.

Tagged as : Cisco 200-355 Dumps, Download 200-355 pdf, 200-355 VCE, 200-355 pass4sure, examcollection 200-355