300-360 Guide

The Improve Guide To 300-360 bible Jun 2021

we provide Approved Cisco 300-360 free draindumps which are the best for clearing 300-360 test, and to get certified by Cisco Designing Cisco Wireless Enterprise Networks. The 300-360 Questions & Answers covers all the knowledge points of the real 300-360 exam. Crack your Cisco 300-360 Exam with latest dumps, guaranteed!

Q1. A customer has deployed an N+N redundant wireless infrastructure. In this deployment, the access points have been salt and peppered between controllers. What configuration would be necessary to cut down on the use of mobility tunnels for voice clients?

A. mobility anchor

B. KIS based CAC

C. media session snooping

D. re-anchor roamed voice clients

Answer: D


Q2. An engineer is preparing for an active site survey of a warehouse and is informed that they should not enter any areas that are blocked by supplies that are difficult to move. Which option describes how the engineer should address this restriction?

A. Extrapolate restricted access areas by drawing circles for AP coverage

B. Survey hallways, common areas, and storerooms.

C. Utilize a predictive tool to define coverage in off-limits areas.

D. Educate the customer about the importance of accurate and complete measurements.

Answer: D


Q3. Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

A. Use the Cisco wireless phone site survey client utility.

B. Use a separate Cisco Wireless Lan Controller.

C. Enable load balance on voice WLANs.

D. Maintain -67dBM as a minimal RSSI.

E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.

F. Enable lower data rates for 2.4-GHz data WLAN.

Answer: A,D,E


Q4. An engineer is determining the signal levels for the wireless cells. Which signal-to-noise ratio is an optimal configuration to achieve?

A. minimum SNR of -33 dBm

B. minimum SNR of -25 dBm

C. minimum SNR of 25 dB

D. minimum SNR of 33 dB

Answer: C

Explanation:

The minimum recommended wireless signal strength for voice applications is -67 dBm and the minimum SNR is 25 dB.

Reference: http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/116057-sitesurvey-guidelines-wlan-00.html


Q5. A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)

A. Use APs with external antennas.

B. Use DoS attack on APs while measuring the throughput.

C. Use APs with built-in antennas.

D. Use a battery pack to power APs.

E. Use a drawing of the office space to draw AP and client placements.

F. Use APs with directional antennas.

Answer: C,D,E


Q6. An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?

A. 100

B. 250

C. 1000

D. 500

Answer: D

Explanation:

You can order Cisco 5500 Series Controllers with support for 12, 25, 50, 100, 250 or 500 APs as the controller's base capacity. You can add additional AP capacity through capacity adder licenses available at 25, 50, 100 and 250 AP capacities. You can add the capacity adder licenses to any base license in any combination to arrive at the maximum capacity of 500 APs.

Reference: http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/112926-5508wlc-license.html


Q7. An engineer is preparing for an indoor wireless LAN survey and is provisioning a survey kit. Which three pieces of equipment should be included? (Choose three.)

A. external connector access point

B. integrated antenna access point

C. coax low-loss cable

D. battery operated power supply

E. range finder

F. Yagi antennas

Answer: B,D,E


Q8. Refer to the exhibit.

While testing the post-deployment WLAN network, you discover that an AP has been placed in a difficult area.

The AP cannot be moved easily because of various requirements. The client performance of various Apple and Microsoft operating system-based products does not meet expectations. Which two options can help mitigate the performance issue? (Choose two.)

A. Add additional APs.

B. Increase the AP power level to maximum.

C. Rotate the AP 90 degrees to change antenna polarity.

D. Replace the AP with an AP and external antenna.

E. Change the AP location to one that is less RF hostile.

Answer: A,D


Q9. An engineer is assigned to replace an older data-grade autonomous wireless network with a Cisco controllerbased wireless network to meet Voice over WLAN needs. The customer also wants all existing cable infrastructure to be reused and no new cable be specified. How should the engineer respond to the customer’s requirements?

A. Implement the wireless network with the restraints and decrease the TPC neighbor threshold to increase Txpower to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.

B. Implement the wireless network with the restraints and utilize high-gain antenna to provide overlapping cellcoverage at sufficient SNR to provide for Voice over WLAN service.

C. Inform the customer that the network will not likely function as desired and a post install survey with thepossibility of some new cable would be recommended.

D. Inform the customer that it is not possible to provide coverage and quality for Voice over WLAN usingexisting AP locations and an entire overbuild will be necessary.

Answer: C


Q10. What is a common cause for signal attenuation?

A. Cinder block wall

B. Office window

C. Metal door

D. Glass wall

Answer: C


To know more about the 300-360, click here.

Tagged as : Cisco 300-360 Dumps, Download 300-360 pdf, 300-360 VCE, 300-360 pass4sure, examcollection 300-360