300-365 Guide

Top 10 discount pack 300-365 for customers (31 to 40)

Download of 300-365 sample question materials and bootcamp for Cisco certification for consumer, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!

2021 Nov 300-365 exams

Q31. You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the two devices. What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP? 

A. UDP 16113 

B. TCP 1613 

C. TCP 16113 

D. UDP 1613 

Answer:


Q32. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead? 

A. 10 Seconds 

B. 60 Seconds 

C. 15 Seconds 

D. 30 Seconds 

Answer:


Q33. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.) 

A. Only factory-configured MAPs can support WGB mode. 

B. MAPs that are configured in WGB mode do not answer S36 radio measurement requests. 

C. A limited subset of Layer 2 security types are supported for wireless clients of a WGB. 

D. There is a limit of 20 wired client devices. 

E. Multiple VLANs are not supported for wireless clients. 

Answer: B,D 


Q34. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking? 

A. Uses existing LWAPP-enabled Cisco Unified Networking components. 

B. Proprietary client hardware or software is required. 

C. Better accuracy and precision. 

D. Reduced calibration effort. 

Answer:


Q35. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.) 

A. All ports participate in the LAG by default when LAG is enabled on the controller, y 

B. Dynamic interfaces and management are moved to port 1 

C. Primary and secondary ports are needed for each interface. 

D. Multiple untagged interfaces to the same port are not allowed. 

E. EtherChannel must be configured for mode "on" on the switch. 

F. Only one functional physical port is needed to continue to pass traffic. 

G. Multiple LAGs are permitted on the controller. 

H. The WLC does not need to be rebooted to enable the LAG configuration. 

Answer: A,D,E,F 


Renovate 300-365 study guide:

Q36. What address do PIM routers listen to in order to automatically discover the best RP for each multicast group? 

A. 224.0.0.13 

B. 224.0.1.39 

C. 224.0.0.14 

D. 224.0.140 

Answer:


Q37. Which two methods to discover a controller does a MAP attempt when it boots up? (Choose two.) 

A. |f Ethernet and wireless are available, it attempts to discover only via Ethernet. 

B. if Ethernet is disconnected, it attempts to connect wirelessly using AWPP. 

C. if only wireless is available and it is configured as a MAP, it does not attempt to connect to a WLC. 

D. If Ethernet and wireless are available, it uses Ethernet first. If it cannot connect via Ethernet, then it chooses wireless. 

E. |f Ethernet is disconnected, it attempts to connect wirelessly using the configured DHCP option. 

Answer: A,B 


Q38. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three) 

A. IGMP snooping is turned off because the client cannot request to join a group, only access points can. 

B. Video-stream for the multicast video is configured in the controller. 

C. WLAN has been set for a QoS value of Platinum. 

D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally. 

E. WLAN has been set for a QoS value of Gold. 

F. RTSP is used to stream the video due to wireless multicast not using acknowledgements. 

Answer: B,D,E 


Q39. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem? 

A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones. 

B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers. 

C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller. 

D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band. 

Answer:


Q40. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group. Which configuration meets this need? 

A. 264 interfaces of/25 sized networks 

B. 132 interfaces of/24 sized networks 

C. 66 interfaces of/23 sized networks 

D. 33 interfaces of /22 sized networks 

Answer:


To know more about the 300-365, click here.

Tagged as : Cisco 300-365 Dumps, Download 300-365 pdf, 300-365 VCE, 300-365 pass4sure, examcollection 300-365