A Review Of Accurate 352-001 samples

we provide Download Cisco 352-001 free practice test which are the best for clearing 352-001 test, and to get certified by Cisco CCDE Written Exam. The 352-001 Questions & Answers covers all the knowledge points of the real 352-001 exam. Crack your Cisco 352-001 Exam with latest dumps, guaranteed!

Q31. Refer to the exhibit. 

In this BGP design, what is the next hop for 10.1.1.0/24 on R8 and R7? 

A. The next hop for 10.1.1.0/24 on R7 is R8 and the next hop for R8 is R7. 

B. The next hop for 10.1.1.0/24 on R7 is R5 and the next hop for R8 is R6. 

C. The next hop for 10.1.1.0/24 on R7 is R6 and the next hop for R8 is R5. 

D. The next hop for 10.1.1.0/24 on R7 is R3 and the next hop for R8 is R4. 

Answer: A 

Q32. Refer to the exhibit. 

You are planning the design of an encrypted WAN. IP packets will be transferred over encrypted GRE tunnels between routers B and C. The packet size is limited to a maximum of 1500 bytes inside the WAN between routers B and C. If endpoint 1 tries to send 1500-byte IP packets to endpoint 2, in what three ways will the network design handle the fragmentation in three different possible network configurations? (Choose three.) 

A. When router B fragments packets after the encryption, router C must reassemble these fragmented packets. 

B. When router B fragments packets before the encryption, router C must reassemble these fragmented packets. 

C. When router B fragments packets after the encryption, the endpoint 2 must reassemble these fragmented packets. 

D. When router B fragments packets before the encryption, endpoint 2 must reassemble these fragmented packets. 

E. When router A fragments packets, router C must reassemble these fragmented packets. 

F. When router A fragments packets, endpoint 2 must reassemble these fragmented packets. 

Answer: ADF 

Q33. Your company plans to implement an Internet gateway router that is performing NAT. This same gateway will be terminating various IPsec tunnels to other remote sites. Which 

address type isappropriate for the ACL that will govern the sources of traffic entering the tunnel in the inside interface? 

A. inside local 

B. inside global 

C. outside local 

D. outside global 

Answer: B 

Q34. Refer to the exhibit. 

You are asked to design this OSPF network to converge within 60 ms for unicast packets after a topology change due to a single link failure. Which technology can be enabled while conforming to the design requirements? 

A. Loop-Free Alternates 

B. BFD 

C. IGP neighbor timer tuning 

D. IGP SPF timer tuning 

E. RSVP-TE Fast Reroute 

Answer: A 

Q35. You are asked to design a large campus network that will be using multicast for data transport. Which feature should be enabled at the Layer 2 access edge for host-only ports? 

A. PortFast 

B. BPDU guard 

C. PIM-SM 

D. PIM query interval 

Answer: A 

Q36. You are designing a network for a branch office. In order to improve convergence time, you are required to use the BFD feature. Which four routing protocols can you use to facilitate this? (Choose four.) 

A. EIGRP 

B. IS-IS 

C. BGP 

D. static 

E. RIP 

Answer: ABCD 

Q37. Refer to the exhibit. 

This Layer 2 ring has 10 VLANs with 1000 MAC addresses in each VLAN. Which protocol or mechanism provides the shortest traffic outage if the link marked with "X" fails? 

A. PVRST 

B. REP 

C. MST 

D. G.8031 

E. BFD 

Answer: B 

Q38. You have been asked to design a high-density wireless network for a university campus. Which three principles would you apply in order to maximize the wireless network capacity? (Choose three.) 

A. Increase the number of SSIDs to load-balance the client traffic. 

B. Choose a high minimum data rate to reduce the duty cycle. 

C. Make use of the 5-GHz band to reduce the spectrum utilization on 2.4 GHz when dual-band clients are used. 

D. Enable 802.11ag channel bonding on both 2.4 GHz and 5 GHz to increase the maximum aggregated cell throughput. 

E. Use directional antennas to achieve better sector separation channel reuse. 

F. Implement a four-channel design on 2.4 GHz to increase the number of available channels. 

Answer: BCE 

Q39. A Tier-3 Service Provider is evolving into a Tier-2 Service Provider due to the amount of Enterprise business it is receiving. The network engineers are re-evaluating their IP/MPLS design considerations in order to support duplicate/overlapping IP addressing from their Enterprise customers within each Layer 3 VPN. Which of the following would need to be reviewed to ensure stability in their network? 

A. Assigning unique Route Target ID's 

B. Assigning unique Route Distinguishers 

C. Assigning unique IP address space for the Enterprise NAT/Firewalls 

D. Assigning unique VRF ID's to each Layer 3 VPN 

Answer: B 

Q40. A company would like to distribute a virtual machine (VM) hosting cluster between three data centers with the capability to move VMs between sites. The connectivity between data centers is IP only and the new design should use the existing WAN. Which Layer 2 tunneling technology do you recommend? 

A. VPLS 

B. L2TPv3 

C. OTV 

D. AToM 

Answer: C