The Secret of 352-001 practice exam

Master the 352-001 CCDE Written Exam content and be ready for exam day success quickly with this Testking 352-001 exam cram. We guarantee it!We make it a reality and give you real 352-001 questions in our Cisco 352-001 braindumps.Latest 100% VALID Cisco 352-001 Exam Questions Dumps at below page. You can use our Cisco 352-001 braindumps and pass your exam.

Q71. As part of a new network design, you are helping the Network Management Team to develop a proactive report to identify places in the network where problems may happen. The network management tool can poll the network devices only via SNMP GET operations. Which two threshold-crossing metrics should you include in this report? (Choose two.) 

A. packet loss 

B. CPU utilization 

C. heat dissipation 

D. IP reachability 

E. energy consumption 

F. link bandwidth utilization 

Answer: BF 

Q72. A service provider creates a network design that runs MPLS in its WAN backbone using OSPF as the IGP routing protocol. What would be two effects of additionally implementing MPLS-TE? (Choose two.) 

A. MPLS-TE is required to reroute traffic within less than 1 second in case of a link failure inside the backbone. 

B. MPLS-TE is required to route different MPLS QoS service classes through different paths. 

C. MPLS-TE and OSPF cannot be used together inside one MPLS network. 

D. MPLS-TE cannot use OSPF for the traffic path calculation. 

E. MPLS-TE is required to create backup paths independently from the IGP. 

Answer: B,E 

Q73. To meet specific business requirements, QoS-marked traffic must be sent over a dedicated link. Which technology fulfills this requirement? 

A. MPLS 

B. Q-in-Q tunneling 

C. policy-based routing 

D. EIGRP with modified metrics 

Answer: C 

Q74. You have been tasked with designing a data center interconnect as part of business continuity. You want to use FCoE over this DCI to support synchronous replication. Which two technologies allow for FCoE via lossless Ethernet or data center bridging? (Choose two.) 

A. EoMPLS 

B. DWDM 

C. Multichassis EtherChannel over Pseudowire 

D. OTV 

E. VPLS 

F. SONET/SDH 

Answer: BF 

Q75. For a storage area network design, which technology allows a switch to support multiple Fibre Channel IDs per fabric port? 

A. N-Port Identifier Virtualization 

B. Inter-Virtual Storage Area Network Routing 

C. Zoning 

D. Fabric Port Trunking 

E. Node Port Virtualization 

F. Expansion Port Trunking 

Answer: A 

Q76. You have been tasked to create a Layer 2 network design that uses vPC to provide resiliency and avoid loops. vPC removes Layer 2 loops while providing redundancy through which mechanism? 

A. dual-active detection 

B. address synchronization 

C. strict forwarding rules 

D. Bridge Assurance 

Answer: C 

Q77. Your design plan includes mutual redistribution of two OSPF networks at multiple locations, with connectivity to all locations in both networks. How is this accomplished without creating routing loops? 

A. Use route maps on the ASBRs to allow only internal routes to be redistributed. 

B. Use route maps on the ASBRs to allow internal and external routes to be redistributed. 

C. Use route maps on the ASBRs to set tags for redistributed routes. 

D. Use route maps on the ASBRs to filter routes with tags so they are not redistributed. 

Answer: D 

Q78. Refer to the exhibit. 

You are developing a migration plan to enable IPv6 in your IPv4 network. Starting at R3 and assuming default IS-IS operations, what is likely to happen when you enable IPv6 routing on the link from R3 to R2? 

A. Only R3 and R2 have IPv4 and IPv6 reachability. 

B. R2 receives an IPv6 default route from R3. 

C. Loopback reachability between all routers for IPv4 is lost. 

D. All routers except R2 are reachable through IPv4. 

E. R3 advertises the link from R3-R2 to R1, R4 and R5 only. 

Answer: C 

Q79. In which two ways is IPv4 and IPv6 traffic handled in a network design that uses QoS deployment options? (Choose two.) 

A. IPv6 and IPv4 traffic is treated in the same way by using a single QoS policy that classifies and matches on both protocols. 

B. IPv6 traffic is treated differently than IPv4 by using the flow-label field, which is built into the IPv6 packet header. 

C. IPv6 traffic does not require QoS because it uses to the flow-label field, which classifies and matches on the IPv6 protocol. 

D. IPv6 traffic is treated differently than IPv4 by using two different QoS policies. 

E. IPv6 traffic is treated differently than IPv4 because it uses only the DSCP value and not the IP precedence. 

Answer: AD 

Q80. You have been hired to redesign a network due to issues with congestion. How will a router function if the QoS mechanism of congestion avoidance is integrated into the existing network design? 

A. the router handles the overflow of traffic by using FIFO B. the router handles the possible buildup of congestion by using WRED 

C. the router forces inbound and outbound traffic to stay within a defined profile by using rate limiting 

D. the router separates packets based on certain characteristics by using NBAR 

E. the router marks packets based on certain characteristics by using PBR 

Answer: B