Amazing cisco 352-001 vce secrets

Cisco 352-001 qualifications make it easier to effectively regulate tremendous work. If you takeCisco 352-001 accreditation, this is able to make it easier to get hold of expertise important effectively utilizing Cisco technological innovation. This is an excellent Cisco if you want to are a Cisco specialized. 352-001 Examination DescriptionIt is known this most up-to-date 352-001 quiz check would be the scorching quiz of Cisco accreditation.

2021 Aug pass4sure 352-001:

Q161. A network design shows two routers directly connected to an Ethernet switch using optical connections. There is an OSPF adjacency between the routers. In this design, which solution will ensure that interface down detection is reported as quickly as possible to the IGP? 

A. optimized OSPF SPF timers 

B. Bidirectional Forwarding Detection 

C. automatic protection switching 

D. optimized OSPF LSA timers 

E. Ethernet OAM CFM monitoring 

Answer: B 

Q162. To improve the stability of a global network, you have been tasked with changing the design to include link-state topology summarization. What are two issues that you should address as part of the design? (Choose two.) 

A. slow convergence 

B. suboptimal routing 

C. traffic black-holing 

D. packet reordering 

Answer: BC 

Q163. When creating a design plan for IPv6 integration, you decide to use stateless encapsulation of IPv6 packets into IPv4 tunnels between subscriber CPEs and a border relay. Which deployment technique allows for this functionality? 

A. 6rd 

B. Dual-Stack Lite 

C. 4rd 

D. DSTM 

Answer: A 

Far out cisco exam 352-001:

Q164. A customer is using a service provider to provide a WAN backbone for a 30-site network. In establishing the network, the customer must work within these constraints: 

The customer has a self-managed MPLS backbone. 

The VPLS WAN backbone of the service provider does not support PIM snooping. 

Multicast VPN must be used for multicast support inside some VRFs. 

What can the customer do so that multicast traffic is NOT flooded to all sites? 

A. Configure static GRE tunnels and run the MPLS and multicast VPN inside these GRE tunnels. 

B. Use Label Switched Multicast for the multicast transport. 

C. Use PIM-SSM as the multicast routing protocol with IETF Rosen Draft multicast VPN. 

D. Configure a static mapping between multicast addresses and MAC addresses. 

E. Use GET VPN to encrypt the multicast packets inside the WAN. 

Answer: A 

Q165. Which technique can you use to detect forwarding path failures at a uniform rate, and reconvergence times will be consistent and predictable when your routers are in the same broadcast domain? 

A. Enable BFD on your routers. 

B. Configure your routers with IP-SLA to ping the peer router. 

C. Configure your routers with IP-SLA and track to ping the peer and switch to a default route if the pings fail. 

D. Tune your routing protocol timers. 

Answer: A 

Q166. In a network design using carrier Ethernet, which three mechanisms can be used to improve Layer 2 down detection and thereby reduce routing convergence time? (Choose three.) 

A. BFD 

B. Ethernet port debounce timers 

C. link-state tracking 

D. object tracking 

E. fast IGP hello 

Answer: ADE 

Q167. As part of a new network design, you are helping the Network Management Team to develop a proactive report to identify places in the network where problems may happen. The network management tool can poll the network devices only via SNMP GET operations. Which two threshold-crossing metrics should you include in this report? (Choose two.) 

A. packet loss 

B. CPU utilization 

C. heat dissipation 

D. IP reachability 

E. energy consumption 

F. link bandwidth utilization 

Answer: BF