Ultimate Guide: sitecom wl-352 v2 001

There several reasons to the candidates to pass your Cisco Cisco certification exam. But the the majority of persuasive reason can be that most in the candidates have took Pass4sures latest Cisco Cisco training study course. There are more affordable Cisco Cisco exam products at Pass4sure for you to make use of. Pass4sure has been within the business regarding IT coaching and certification for several years and it becomes much better and much better. If you are among those individuals who want to receive the Cisco certification, Pass4sure provides you with a new perfect along with preferred approach in your Cisco 352-001 exam preparation. The actual high passing ratio regarding our clients is a good proof for you to hold faith in our Cisco 352-001 demos.

2021 Sep driver sitecom wl-352 v2 001:

Q141. You are designing an 802.11 wireless network to include a controller as a central configuration point and access points across several remote sites. Which two aspects will manage the flow of the traffic to meet these design considerations? (Choose two.) 

A. WLAN local switching with VLAN mapping requires that VLAN ID that is mapped on the AP to match a dynamic interface that is configured on the wireless LAN controller. 

B. Layer 3 roaming is not supported for locally switched WLANs. 

C. The 802.1x authentication for a client associated to an AP on a locally switched WLAN is always handled at the wireless LAN controller side. 

D. The access point can receive multicast traffic in the form of multicast packets from the WLC. 

E. WLAN access lists can be applied only to centrally switched WLANs. 

Answer: BE 

Q142. You work as a network designer for a company that is replacing their Frame Relay WAN with an MPLS VPN service, where the PE-to-CE routing protocol is BGP. The company has 3000 routes in their distribution routers, and they would like to advertise their access routers through the MPLS network. Their service provider, however, only supports 1000 prefixes per VRF. Which two design solutions can be applied to ensure that your access routers will be able to reach all devices in your network? (Choose two.) 

A. Use prefix lists on your distribution routers to control which routes are sent to the MPLS network. 

B. On your distribution routers, configure null routes and aggregate routes for the prefixes in your network. 

C. Configure your distribution routers to send a default route to the MPLS network. 

D. Summarize the routes on the MPLS WAN interfaces of your distribution routers. 

Answer: BC 

Q143. During a corporate merger, a network designer is asked for a solution that will provide connectivity between the two enterprise networks. The solution must have the ability to support video sessions so that the CEO can message merger activities to the employees. The designer decides to consider multicast as a transport with MSDP to provide redundancy. Which transport feature does the network designer need to apply to the interconnecting firewall to ensure that Source-Active messages between the MSDP peers can be sent in both enterprise networks? 

A. unicast over a UDP connection 

B. multicast over a UDP connection 

C. unicast over a TCP connection 

D. multicast over a TCP connection 

Answer: C 

Q144. Which two design aspects should a metro service provider consider when planning to deploy REP for his backbone? (Choose two.) 

A. Two REP segments can be connected redundantly at two points, one connection will be blocked as per the STP defined in IEEE 802.1d. 

B. UDLD can be enabled on REP interfaces to detect unidirectional failures. 

C. The guaranteed convergence recovery time is less than 50 ms for the local segment. 

D. A REP segment is limited to a maximum of seven devices. 

E. VLAN load balancing for optimal bandwidth usage is supported in any REP segment. 

Answer: BE 

Q145. You are designing a network to support data, voice and video. Which two main factors will you address to improve network convergence? (Choose two.) 

A. event propagation delay 

B. failure detection delay 

C. forwarding engine update delay 

D. routing table recalculation delay 

Answer: BD 

Down to date sitecom wl-352 v3 001 driver:

Q146. You are designing a Group Encrypted Transport virtual private network solution for an existing branch network. The existing network has the following characteristics: 

. 50 remote sites (with an additional 30 remote sites expected over the next 3 years) . Connectivity between all sites is via Multiprotocol Label Switching Layer 3 virtual private network service from a single provider . Open Shortest Path First is the routing protocol used between provider edge and customer edge routers . The customer edge routers will become group members performing the encryption between sites 

Which additional routing protocol would you use for the overlay routing between the group members? 

A. Open Shortest Path First (with a different process ID) 

B. Enhanced Interior Gateway Routing Protocol 

C. No additional protocol is necessary. 

D. External Border Gateway Protocol 

E. Routing Information Protocol Version 2 

F. Next Hop Resolution Protocol 

Answer: C 

Q147. You have been tasked with designing a data center interconnect to provide business continuity. You want to encrypt the traffic over the DCI using IEEE 802.1AE MACsec to prevent the deployment of any firewall or IPS. Which two interconnect technologies support MACsec? (Choose two.) 

A. EoMPLS 

B. MPLS Layer 3 VPN 

C. DMVPN 

D. OTV 

E. VPLS 

F. GET VPN 

Answer: AE 

Q148. After the recent implementation of a new design that incorporated GRE tunnels into the network, the network operations staff is seeing the following syslog message in multiple routers on the network - %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing. 

From a design perspective, what was not taken into account prior to implementing the solution? 

A. The neighboring routers cannot respond within the specified hold time. 

B. The interface on the router that is the source of the tunnel is down. 

C. The interface on the neighboring router that is the source of the tunnel is down. 

D. The router is learning the route to the tunnel destination address using the tunnel interface. 

E. The tunnel interface on the router is not receiving any keepalives within the specified hold time. 

Answer: D 

Q149. Which two techniques are used in a network design to slow down the distribution of topology information caused by a rapidly flapping link? (Choose two.) 

A. Bidirectional Forwarding Detection 

B. IP event dampening 

C. link-state incremental SPF 

D. link-state partial SPF 

E. LSA throttling 

F. SPF throttling 

Answer: BE 

Q150. A metro service provider is planning Resilient Ethernet Protocol for his backbone. Which two aspects must be considered before the network design is finalized? (Choose two.) 

A. Two Resilient Ethernet Protocol segments can be connected redundantly at two points. One connection will be blocked, using the Spanning Tree Protocol defined in IEEE 802.1D. 

B. UniDirectional Link Detection Protocol can be enabled on Resilient Ethernet Protocol interfaces to detect unidirectional failures. 

C. The guaranteed convergence recovery time is less than 50 ms for the local segment. 

D. A Resilient Ethernet Protocol segment is limited to a maximum of seven devices. 

E. VLAN load balancing for optimal bandwidth usage is supported in any Resilient Ethernet Protocol segment. 

Answer: BE