How to pass balluff bis m-352-001-s115 in Sep 2021

For the limited time exclusively, buy the 100 % couple of Cisco 352-001 exam research components, plus help save 10% for your invest in. Reinvest that cash inside you success flow, after you become the after that Cisco qualifications via moving your own 352-001 exam. However, you might be familiar with additional 352-001 research components, exclusively Exambible provides the 352-001 research components that may allow you to speedily hold the practical experience you must correctly introduction your job during the This business.

2021 Sep sitecom wl-352 v3 001 driver:

Q131. What is a design aspect regarding multicast transport for MPLS Layer 3 VPNs using the Rosen Draft implementation? 

A. LDP is the multicast control plane protocol. 

B. Multicast traffic is forwarded over GRE tunnels. 

C. Multicast traffic is forwarded over LDP or RSVP signaled LSPs. 

D. Using the MDT SAFI in BGP ensures that PIM can be disabled in the core. 

Answer: B 

Q132. An MPLS service provider is offering a standard EoMPLS-based VPLS service to Customer A, providing Layer 2 connectivity between a central site and approximately 100 remote sites. Customer A wants to use the VPLS network to carry its internal multicast video feeds, which are sourced at the central site and consist of 20 groups at 5 Mb/s each. Which service provider recommendation is the most scalable? 

A. EoMPLS-based VPLS already carries multicast traffic in a scalable manner. 

B. Replicate the multicast traffic on the P routers. 

C. Replace VPLS with a Layer 3 MVPN solution to carry the streams between sites. 

D. Use GRE tunnels to carry the streams between sites. 

Answer: C 

Q133. When you design a network, when would it be required to leak routes into a Level 1 area? 

A. when a multicast RP is configured in the nonbackbone area 

B. when MPLS L3VPN PE devices are configured in the Level 1 areas 

C. when equal cost load balancing is required between the backbone and nonbackbone areas 

D. when unequal cost load balancing is required between the backbone and nonbackbone areas 

Answer: B 

Q134. When a design calls for spanning VLANs across a campus network, what are two issues that need to be addressed in the design? (Choose two.) 

A. network convergence 

B. network accessibility 

C. fault isolation 

D. application scalability 

E. user experience 

Answer: AC 

Q135. You have been asked to design a high-density wireless network for a university campus. Which three principles would you apply in order to maximize the wireless network capacity? (Choose three.) 

A. Increase the number of SSIDs to load-balance the client traffic. 

B. Choose a high minimum data rate to reduce the duty cycle. 

C. Make use of the 5-GHz band to reduce the spectrum utilization on 2.4 GHz when dual-band clients are used. 

D. Enable 802.11ag channel bonding on both 2.4 GHz and 5 GHz to increase the maximum aggregated cell throughput. 

E. Use directional antennas to achieve better sector separation channel reuse. 

F. Implement a four-channel design on 2.4 GHz to increase the number of available channels. 

Answer: BCE 

Abreast of the times actualtests 352-001:

Q136. A large service provider offers VoIP and Video services to business customers. Which three areas should the service provider monitor related to these services? (Choose three.) 

A. bandwidth utilization 

B. service response time 

C. packet loss 

D. jitter 

E. latency 

F. availability 

Answer: CDE 

Q137. Which three reasons to deploy an IDS sensor in promiscuous mode when you design a security solution are true? (Choose three.) 

A. Solution should be resistant to sensor failure. 

B. Solution should allow for stream normalization. 

C. Solution should not impact jitter and latency for voice traffic. 

D. Solution should allow for signature-based pattern matching. 

E. Solution should allow to deny packets inline. 

Answer: ACD 

Q138. When designing a large full mesh network running OSPF, how would you reduce LSA repetition? 

A. Elect a DR and BDR. 

B. Use access control lists to control outbound advertisements. 

C. Choose one or two routers to re-flood LSA information. 

D. Put each of the point-to-point links in your full mesh networking into a separate area. 

Answer: C 

Q139. You are using iSCSI to transfer files between a 10 Gigabit Ethernet storage system and a 1 Gigabit Ethernet server. The performance is only approximately 700 Mb/s and output drops are occurring on the server switch port. Which action will improve performance in a cost-effective manner? 

A. Use a WRED random drop policy. 

B. Increase the queue to at least 1 GB. 

C. Enable the TCP Nagle algorithm on the receiver. 

D. Change the protocol to CIFS. 

Answer: A 

Q140. A company has these requirements for access to their wireless and wired corporate LANs using 802.1x: 

. Client devices that are corporate assets and have been joined to the Active 

Directory domain are allowed access. 

. Personal devices must not be allowed access. 

. Clients and access servers must be mutually authenticated. 

Which solution meets these requirements? 

A. Protected Extensible Authentication Protocol/Microsoft Challenge Handshake Authentication Protocol Version 2 with user authentication 

B. Extensible Authentication Protocol-Transport Layer Security with machine authentication 

C. Extensible Authentication Protocol-Transport Layer Security with user authentication 

D. Protected Extensible Authentication Protocol/Microsoft Challenge Handshake Authentication Protocol Version 2 with machine authentication 

Answer: B