It is impossible to pass Fortinet nse4 exam dump exam without any help in the short term. Come to Pass4sure soon and find the most advanced, correct and guaranteed Fortinet nse4 dumps practice questions. You will get a surprising result by our Refresh Fortinet Network Security Expert 4 Written Exam (400) practice guides.
Q1. - (Topic 20)
Examine at the output below from the diagnose sys top command: # diagnose sys top 1 Run Time: 11 days, 3 hours and 29 minutes 0U, 0N, 1S, 99I; 971T, 528F, 160KF sshd 123 S 1.9 1.2 ipsengine 61 S < 0.0 5.2 miglogd 45 S 0.0 4.9
pyfcgid 75 S 0.0 4.5
pyfcgid 73 S 0.0 3.9
Which statements are true regarding the output above? (Choose two.)
A. The sshd process is the one consuming most CPU.
B. The sshd process is using 123 pages of memory.
C. The command diagnose sys kill miglogd will restart the miglogd process.
D. All the processes listed are in sleeping state.
Q2. - (Topic 15)
Review the configuration for FortiClient IPsec shown in the exhibit.
Which statement is correct regarding this configuration?
A. The connecting VPN client will install a route to a destination corresponding to the student_internal address object.
B. The connecting VPN client will install a default route.
C. The connecting VPN client will install a route to the 172.20.1.[1-5] address range.
D. The connecting VPN client will connect in web portal mode and no route will be installed.
Q3. - (Topic 13)
Which statements are correct for port pairing and forwarding domains? (Choose two.)
A. They both create separate broadcast domains.
B. Port Pairing works only for physical interfaces.
C. Forwarding Domain only applies to virtual interfaces.
D. They may contain physical and/or virtual interfaces.
Q4. - (Topic 14)
Which of the following statements are correct about the HA command diagnose sys ha reset-uptime? (Choose two.)
A. The device this command is executed on is likely to switch from master to slave status if override is disabled.
B. The device this command is executed on is likely to switch from master to slave status if override is enabled.
C. This command has no impact on the HA algorithm.
D. This command resets the uptime variable used in the HA algorithm so it may cause a
new master to become elected.
Q5. - (Topic 15)
Review the IPsec phase 2 configuration shown in the exhibit; then answer the question below.
Which statements are correct regarding this configuration? (Choose two.).
A. The Phase 2 will re-key even if there is no traffic.
B. There will be a DH exchange for each re-key.
C. The sequence number of ESP packets received from the peer will not be checked.
D. Quick mode selectors will default to those used in the firewall policy.
Q6. - (Topic 15)
Review the IKE debug output for IPsec shown in the exhibit below.
Which statements is correct regarding this output?
A. The output is a phase 1 negotiation.
B. The output is a phase 2 negotiation.
C. The output captures the dead peer detection messages.
D. The output captures the dead gateway detection packets.
Q7. - (Topic 1)
Which network protocols are supported for administrative access to a FortiGate unit? (Choose three.)
Q8. - (Topic 14)
In HA, the option Reserve Management Port for Cluster Member is selected as shown in the exhibit below.
Which statements are correct regarding this setting? (Choose two.)
A. Interface settings on port7 will not be synchronized with other cluster members.
B. The IP address assigned to this interface must not overlap with the IP address subnet assigned to another interface.
C. When connecting to port7 you always connect to the master device.
D. A gateway address may be configured for port7.
Q9. - (Topic 21)
Which statements are true regarding IPv6 anycast addresses? (Choose two.)
A. Multiple interfaces can share the same anycast address.
B. They are allocated from the multicast address space.
C. Different nodes cannot share the same anycast address.
D. An anycast packet is routed to the nearest interface.
Q10. - (Topic 15)
Which statements are correct properties of a partial mesh VPN deployment. (Choose two.)
A. VPN tunnels interconnect between every single location.
B. VPN tunnels are not configured between every single location.
C. Some locations are reached via a hub location.
D. There are no hub locations in a partial mesh.
To know more about the NSE4, click here.